What to do if my Fairland Heat Pump display is normal but there is no heating?
If your Fairland Heat Pump's display is normal, but it's not heating, it might be due to the set temperature being too low. Ensure you set the temperature to a proper heating level. Also, consider that there might be a 3-minute start delay; wait patiently to see if the heating starts.
Why is my Fairland Heat Pump not running?
If your Fairland Heat Pump isn’t running, it could be due to several reasons: * There might be no power. In this case, wait until the power recovers. * The power switch might be off. Ensure the power switch is turned on. * A fuse might have burned out. Check the fuse and replace it if necessary. * The breaker might be off. Check the breaker and turn it on.
What to do if Fairland Inverter-Plus fan is running but with insufficient heating?
If your Fairland Heat Pump's fan is running but there is insufficient heating, check for the following: * The evaporator could be blocked. Remove any obstacles. * The air outlet might be blocked. Clear any obstructions. * There may be a 3 minutes start delay. Wait patiently.
Important notes on power-off memory, usage limitations, handling, and fire prevention.
Emphasizes that installation must be performed by a professional team for safety and to prevent damage.
Specifies breaker, fuse, and cable types for safe and compliant electrical connections.
Illustrates electrical connections for 230V and 400V power supplies for proper setup.
Checklist for verifying all wirings, connections, and physical obstacles before initial power-on.
Steps for performing the initial startup and testing of the heat pump after installation.
General| Model | Inverter-Plus Series |
|---|---|
| Noise Level | 50 dB(A) |
| Control | Inverter |
| Heating Capacity | 12 kW |
| Power Supply | 220-240V, 50Hz |
| Operating Temperature Range (Heating) | -15°C to 43°C |
To Next Page