What to do if my Fairland IPH100T Heat Pump display is normal but there is no heating?
If your Fairland Heat Pump's display is normal, but it's not heating, it might be due to the set temperature being too low. Ensure you set the temperature to a proper heating level. Also, consider that there might be a 3-minute start delay; wait patiently to see if the heating starts.
Why is my Fairland IPH100T Heat Pump not running?
If your Fairland Heat Pump isn’t running, it could be due to several reasons: * There might be no power. In this case, wait until the power recovers. * The power switch might be off. Ensure the power switch is turned on. * A fuse might have burned out. Check the fuse and replace it if necessary. * The breaker might be off. Check the breaker and turn it on.
What to do if Fairland IPH100T fan is running but with insufficient heating?
If your Fairland Heat Pump's fan is running but there is insufficient heating, check for the following: * The evaporator could be blocked. Remove any obstacles. * The air outlet might be blocked. Clear any obstructions. * There may be a 3 minutes start delay. Wait patiently.
Crucial notice that the heat pump is exclusively for heating pool water.
Warning against lifting the unit by its water unions to prevent internal damage.
Caution against using or storing flammable materials near the unit.
Guidance on immediate action and dealer contact for abnormal operations.
Instruction to keep the main power switch out of children's reach.
Recommendation to disconnect power during lightning storms.
Critical considerations and checks before proceeding with installation.
Instruction to use hard pipes for connecting water unions.
Requirements for choosing a suitable installation site with adequate airflow.
Procedures for securing the unit and connecting the water pump.
Guidelines for connecting the correct power supply and earthing.
Emphasis on professional wiring according to circuit diagrams.
To Next Page
General