What to do if my Fairland Heat Pump display is normal but there is no heating?
If your Fairland Heat Pump's display is normal, but it's not heating, it might be due to the set temperature being too low. Ensure you set the temperature to a proper heating level. Also, consider that there might be a 3-minute start delay; wait patiently to see if the heating starts.
Why is my Fairland IPH30 Heat Pump not running?
If your Fairland Heat Pump isn’t running, it could be due to several reasons: * There might be no power. In this case, wait until the power recovers. * The power switch might be off. Ensure the power switch is turned on. * A fuse might have burned out. Check the fuse and replace it if necessary. * The breaker might be off. Check the breaker and turn it on.
What to do if Fairland Heat Pump fan is running but with insufficient heating?
If your Fairland Heat Pump's fan is running but there is insufficient heating, check for the following: * The evaporator could be blocked. Remove any obstacles. * The air outlet might be blocked. Clear any obstructions. * There may be a 3 minutes start delay. Wait patiently.
General| Model | IPH30 |
|---|---|
| Heating Capacity (Air 27°C/Water 27°C/Humidity 80%) | 30 kW |
| Water Connection | 50 mm |
| Type | Heat Pump |
| Power Supply | 220~240V/1Ph/50Hz |
Provides crucial reminders and warnings regarding heat pump operation, maintenance, and safety.
Step-by-step guide for installing the heat pump, including location and ventilation requirements.
Covers fixing the frame, connecting the water pump, and managing condensation.
Details power supply, earthing, wiring by professionals, and protective device specifications.
Instructions for connecting the power supply wires to the heat pump unit.
Provides electrical diagrams for 230V and 400V power supplies.
To Next Page