What to do if my Fairland Heat Pump display is normal but there is no heating?
If your Fairland Heat Pump's display is normal, but it's not heating, it might be due to the set temperature being too low. Ensure you set the temperature to a proper heating level. Also, consider that there might be a 3-minute start delay; wait patiently to see if the heating starts.
Why is my Fairland IPH35 not running?
If your Fairland Heat Pump isn’t running, it could be due to several reasons: * There might be no power. In this case, wait until the power recovers. * The power switch might be off. Ensure the power switch is turned on. * A fuse might have burned out. Check the fuse and replace it if necessary. * The breaker might be off. Check the breaker and turn it on.
What to do if Fairland IPH35 Heat Pump fan is running but with insufficient heating?
If your Fairland Heat Pump's fan is running but there is insufficient heating, check for the following: * The evaporator could be blocked. Remove any obstacles. * The air outlet might be blocked. Clear any obstructions. * There may be a 3 minutes start delay. Wait patiently.
Step-by-step guide on how to operate the heat pump controls and features.
Instructions for routine cleaning, checks, and preparing the unit for winter.
Important considerations and warnings before proceeding with the heat pump installation.
Detailed steps and requirements for correctly installing the heat pump unit.
Procedures for testing the heat pump after it has been installed.
To Next Page
General