What to do if my Fairland Turbo Silence IXR46 display is normal but there is no heating?
If your Fairland Heat Pump's display is normal, but it's not heating, it might be due to the set temperature being too low. Ensure you set the temperature to a proper heating level. Also, consider that there might be a 3-minute start delay; wait patiently to see if the heating starts.
Why is my Fairland Turbo Silence IXR46 Heat Pump not running?
If your Fairland Heat Pump isn’t running, it could be due to several reasons: * There might be no power. In this case, wait until the power recovers. * The power switch might be off. Ensure the power switch is turned on. * A fuse might have burned out. Check the fuse and replace it if necessary. * The breaker might be off. Check the breaker and turn it on.
What to do if Fairland Heat Pump fan is running but with insufficient heating?
If your Fairland Heat Pump's fan is running but there is insufficient heating, check for the following: * The evaporator could be blocked. Remove any obstacles. * The air outlet might be blocked. Clear any obstructions. * There may be a 3 minutes start delay. Wait patiently.
Essential checks and preparations required before operating the heat pump for the first time.
Step-by-step guide on using the heat pump controls, including power, temperature, and mode adjustments.
Details on selecting the location, required clearances, and connecting pipes.
Procedures for testing the heat pump after installation, including inspections and operational checks.
Schematics illustrating the connection of the heat pump to 230V and 400V power supplies.
To Next Page
General