Fakir STUBBY - Cleaning and After-Use Care

22
EN
Be careful when you are trimming without the comb as when the Trimmer is turned on it
will trim every hair it touches.
Cleaning
• Clean the Trimmer after each use.
• Always switch Trimmer OFF, unplug and remove power supply cord from Trimmer
before cleaning.
• Never immerse the Trimmer in water or rinse under the tap.
• Do not use abrasive cleaning agents, scourers or aggressive liquids such as alcohol,
gasoline, or acetone to clean the Trimmer and attachments.
• Never clean, replace or remove Trimmer comb with motor ON.
• Do not apply pressure to cutters.
• Do not touch cutters with hard objects as this may damage them.
• Use a soft, dry cloth to clean Trimmer handle.
During Use
• If cut hairs have accumulated in the comb area, turn Trimmer off, pull the comb off
Trimmer and remove hairs by shaking, blowing or using cleaning brush provided.
After Each Use
• Make sure the Trimmer is switched OFF and disconnected from the electrical outler.
• Remove the Trimming Comb and clean with the brush. Remove the cutting unit by
pushing against the teeth of the cutting unit (g. 11) and rinse under warm tap water
(g. 12A and 12B) or use the brush supplied. Dry with towel thoroughly.
• Place the cutting unit back by inserting the notch of the cutting unit into the guiding
slot (g. 13).
12B
12A
Replacing The cutting Unit
• If your cutters become damaged or worn, do not continue using the Trimmer. Replace
cutters immediately.
• Open the cutting unit.
• Remove the old cutting unit by pushing against the teeth of the cutting unit (g. 11).
• Insert the notch of the new cutting unit into the guiding slot (g. 13).
• Push the cutting unit back onto the Trimmer until you hear a ‘click’ (g. 14).
STUBBY