19
EN
3. Clean the plasma dust collector
Use mild detergent that is of neutral acidity. Use a scouring pad or toothbrush to clean the
dust collector.
Achieve better result with warm water (below 40C).
If it is hard to eliminate all dirt, presoak with diluted detergent and then use a toothbrush to
scrub.
• Please beware not to damage any wiring while cleaning the dust collector. In case if any
electrical discharge is broken, the device will lose part of or all of its dust collection function.
• Any broken wire should be thrown away instead of being left inside the unit. Otherwise,
short, circuit or high-voltage spark would be resulted. Also, the circuit control of the device
would be affected.
• Please contact authorized Fakir Service for electrical discharge wire.
• Please do not clean using acidic or alkaline detergent that can create rust on the surface
of device.
To Next Page
Loading...
