fakro AMZ - Restoring default parameters

14/1 6
1
2
3
4
2
1
2
2
1
3
x1
x5
t=5sec.
Mode of work and automatic control
Change of sensitivity level of the night mode
It is possible to choose between 4 sensitivity levels of the night
mode. No. 2 is default mode of the sensitivity level. In order to change
sensitivity level of the night mode it is necessary to press SELECT and
UP/DOWN buttons.
1 . Press and hold SELECT  and then...
2. By pressing one of the operating buttons  or  or  choose
requested value.
3. Release SELECT  button.
Restoring default parameters
1 . Press and hold for 5 sec. programming button P on the awning blind
until single blink of motor status LED and then...
2. Not releasing P button press manual operating button for longer
than 1 sec.
3. Correct restoring of the default parameters – motor status LED
blinks 5 times