fakro AMZ - Assigning the device to the operating buttons of the controller - ASSOCIATE function

8/1 6
1
2
3
IN/EX
t<1sec.
x1
x1
2
3
4
1
2
3
x1
1
2
3
4
5. Press the programming button on the awning blind for longer than 1
sec.
6. The controller signals
 correct assigning – LEDs 2,3,4 light up for 2 sec.
 Incorrect assigning – LEDs 1 ,2,3 blink three times
Within 1 second press the sequence of buttons:
2. Press the In/Ex button momentarily and then...
3. Press one of the operating buttons  or  or 
4. Readiness to assign the device is signalled by the controller –
- LEDs 1 ,2,3 light up for 1 0 sec.
Assigning the device to the operating buttons of the controller –
ASSOCIATE function.
Please find below exemplary procedure of adding the device to the
operating buttons of the controller (ASSOCIATE FUNCTION):
In order to control the device (the awning blind):
1 . By pressing button  choose one of four channels which will be used
for operating the blind and then...
Device programming