EasyManua.ls Logo

Falcon U842 - Safety and Precautions; General Safety Guidelines; Blade Guard Installation; Li-Po Battery Charging Procedures

Falcon U842
6 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1.7*6PB Screw
1. Charge the Baery
2. Warnings
Connect the Li-Po baery to USB before plugging the USB to power or your
computer. One end of the USB charger goes into any free port on your
computer or USB power bank. The other end plugs into your baery. You
may leave the baery in your copter, or remove it for external charging. While
charging, the light will be on solid red. When charging is complete, the light
will blink. The recharge me should be around 120 minutes.When the baery
runs low, the transmier will acvated a “di, di” sound alarm, and the LED lights
on the quadcopter will flash. This indicates that the baery has only a short me
le, so fly the quadcopter back immediately for retrieval.
1.This product is only suitable for competent persons age 14+. This machine
is not a toy for children. It is a hobby flying drone, with fast-spinning propellers.
Use of this product naturally incurs risk of injury, especially if it is misused.
Purchaser accepts this risk by purchasing or using this product.
2.To use this product, make sure you have a large open space, not too close to
people, buildings, or power lines.
3.Please do not use this helicopter in bad weather, such as in strong wind, rain
or snow.
a problem, please contact a local agent for repairs.
5.The product contains many electronic parts, which must be kept dry. Please
avoid exposure to moisture.
should not be expose to heat. Please avoid long exposure to heat or bright
sunlight, which may harm the products exterior.
injury or damage.
8.When you are using these products, please follow all local laws and rules
regarding remote control flying drones.
1. The blade guards are removable. To install each blade guard, press the square
area at the boom of the guard against the matching secon of the copter. Use
the supplied screws to aach each of the 4 guards.
2. Keep the guards installed to protect the copter and users, or remove the guards
for lighter weight and more speed and maneuverability. Note that the blades
(propellers) are easy to replace, but each blade is different. If the incorrect
rotaon-style of blade is used, the quadcopter will not fly.
*This product is equipped with a Li-Po baery. Please take note of appropriate
safety precauons when not in use.
*When the baery is not being used for a long me, remove it and put it in a safe
dry place.
PRECAUTIONS
BLADE GUARD INSTALLATION
CHARGING LI-PO BATTERY
3 4