Why doesn't the FANATEC Video Gaming Accessories Universal Hub USB port send data to my phone?
The USB port on the Universal Hub is designed only for charging your mobile phone during gameplay. The app developer or provider is responsible for apps and data transfer from games to the apps.
What to do if the FANATEC Video Gaming Accessories USB port does not charge my mobile device?
Ensure you're using the USB connector cable that came with your mobile phone or a USB cable specifically designed for your mobile phone. Also, if you're trying to charge a tablet, some models might need a stronger power source than the USB port can provide.
What to do if the FANATEC Clubsport tuning display is not working?
If the tuning display isn't showing anything or is only partially working, remove the tuning display from the Universal Hub and check that all the pins are present and not bent or broken. Also, inspect the pins inside the Universal Hub's quick release to ensure they are not bent or damaged.
How to flip the tuning display on FANATEC Video Gaming Accessories Universal Hub?
It is not possible to flip the tuning display due to its design. To change the display's orientation, you must pull it out and push it back into the desired position.
What to do if FANATEC Controller pedal signal behaviour in game feels strange?
If the pedal signal behavior feels strange, connect the ClubSport Pedals V3i directly to your PC or through the wheel base. Then, start the PC driver and check the indicator bars of each pedal while pressing them. You might need to manually calibrate the minimum and/or maximum positions or reactivate the ‘Auto calibration mode’ to adjust the pedal signal behaviour according to your preference.
What to do if FANATEC Controller pedal signals are not correctly indicated after startup?
When powering ON the ClubSport Pedals V3i in ‘Auto calibration mode’, push every pedal lever first to the maximum position and then back to the minimum position. After this, pressing the corresponding pedal lever should give a fine signal from that pedal.
Why does my PC not boot when FANATEC Controller ClubSport Pedals V3i are connected to USB?
This issue is related to the BIOS of some main board manufacturers. To resolve this, boot the PC first, and then plug the ClubSport Pedals V3i into the USB port.
What to do if FANATEC Controller brake pedal seems to become weaker after playing a while?
If the brake pedal feels weaker after use, check your preload screw adjustment. The issue might be related to damages at the PU foam stick inside the brake pedal lever, which can occur if the preload screw is not correctly adjusted within the scale.
How to recalibrate FANATEC Controller after firmware update?
After a firmware update of the ClubSport Pedals V3i, the manually calibrated pedal positions are lost and must be manually calibrated again.
General| Connectivity | USB |
|---|---|
| Force Feedback | Yes |
| Motor Type | Brushless servo motor |
| Shifter Included | No |
| Platform | PC, PlayStation, Xbox |
| Pedals Included | No |
| Compatibility | PC, PlayStation, Xbox |
| Rotation Angle | 1080 degrees |
| Pedals | Sold separately |
| Shifter | Sold separately |
| Wheel Rims | Interchangeable |
Potential seizures from flashing lights in video games.
Risks of repetitive strain injuries from input device use.
Proper power source connection and protection against electrical hazards.
Diagram and explanation of connector sockets for various peripherals.
Instructions for replacing the throttle spring with a stronger one.
Adjusting the brake pedal preload for stiffness.
Step-by-step guide for installing the damper kit.
How to update the device firmware and PC drivers for optimal performance.
Step-by-step guide for updating the ClubSport Pedals V3i firmware.
Detailed guide for precise manual calibration of pedals via PC driver.
Solutions for lost calibration, grinding noise, and recognition problems.
Addressing strange pedal signal behavior and PC boot problems.
To Next Page
