Need help?Do you have a question about the FANATEC CSL DD and is the answer not in the manual?
General| Max Torque | 8 Nm |
|---|---|
| Connectivity | USB |
| Type | Direct Drive |
| Compatibility | PC, Xbox |
| Connections | USB, Power |
Decide on hard-mounting or table clamp, connect steering wheel and PC/Xbox via USB. Follow chapter sequence for assembly.
Insert T-nuts into underside/sides of wheel base for mounting. Position T-nuts to suit mounting surface holes.
Instructions for attaching the CSL DD to a table or desk using the optional CSL Table Clamp for easy removal.
Slide Fanatec steering wheel with QR1 or QR1 Lite onto wheel base shaft. Ensure groove faces upwards.
Connect peripherals like shifters, pedals, and handbrake to the CSL DD using appropriate ports. Use included USB cable.
View compatible accessories like CSL DD Table Clamp, Boost Kit 180, shifters, and Podium Mounting Brackets.
Update CSL DD firmware and drivers using a Windows PC. Essential for functionality, compatibility, and communication.
Power on CSL DD by pressing button. Perform start-up calibration. Turn off by holding power button for 3 seconds.
Cycle through PC, Xbox, and ClubSport modes via power button. LED indicates current mode. Check steering wheel guide.
Manually calibrate the wheel centre position if indicated by 'CAL' flashing. Refer to steering wheel quick guide or PC driver.
Calibrate H-pattern shifters. Follow on-screen prompts for gear positions. Refer to steering wheel quick guide for details.
Access Tuning Menu via steering wheel button. Navigate using D-Pad or FunkySwitch™. Adjust parameters for performance.
Switch between Standard (core parameters) and Advanced (all parameters) tuning menus. Reset profiles to default values.
Adjust steering wheel rotation degrees. Set to 90°, 2520°, or AUTO for game/driver control. Default is AUTO.
Control maximum motor strength for force feedback effects. OFF disables FF, 100 provides maximum power. Avoid clipping.
Reduce FFB output for consistent linearity. LIN for linear scaling, PEA for peak. Affects max torque output.
Add damping to steering wheel. Adjust from OFF to 100. Useful for oversteer control and reducing oscillation.
Simulate mechanical steering feel. Higher settings increase resistance for driving without power steering or wide tyres.
Simulate steering weight. Useful for lighter wheels. Smoothes Natural Friction on direction changes.
Smooths and interpolates FFB by filtering game output without detail loss. OFF is unfiltered, 20 is highest filter.
Adjusts overall intensity and smoothness of force effects. 000 is smoothest, 100 is sharpest. Refines harsh signals.
Modify FFB signals (Force, Spring, Damper). Adjust values carefully to avoid center calibration issues or overheating.
Sets activation point for brake pedal vibration with compatible pedals. Useful for threshold braking technique.
Adjust strength of shock/vibration in steering wheel and pedals. Motors can be used directly by game.
Configure Multi Position Switch function: AUTO, ENC, CONST, PULSE. Only for specific Fanatec steering wheels.
Configure analogue paddles for Clutch Bite Point, Clutch/Handbrake, Brake/Throttle, or Mappable Axes.
Adjusts force needed for 100% brake input with load cell pedals. OFF requires least pressure, 100 requires most.
Confirms compliance with European product regulations and basic safety requirements for technical products.
Confirms compliance with FCC rules, part 15, for class B digital devices. Subject to two conditions for operation.
To Next Page
