20 20
FORCE / SPRING / DAMPER EFFECT
FOR range: OFF 010 … 120 FOR default: 100
SPR range: OFF
010 … 120 SPR default: 100
DPR range: OFF
010 … 120 DPR default: 100
These FFB modiers allow you to change the FFB signals of a game (only
applicable if games support these eects). Theoretically, there are three
signal types which a game can send. Force (forces the steering wheel in a
specic direction). Spring (pulls the steering wheel towards the dynamic
centre). Damper (creates friction)
NOTE: Not every game uses all three types of eects and some games use
only one type to create all three eects.
IMPORTANT: If Spring is adjusted to low values or OFF, the wheel base
will not be able to move the attached steering wheel to the correct centre
position after a centre calibration is performed. Only adjust these values
higher than 100% if the FFB eects are not strong enough and weaker in
comparison to other games. Raising one or more of these values may result
in higher load on the motor and increase heat generation.
5.6.10
BLI
(
BRAKE LEVEL INDICATOR
)
BLI range: 001 … 100 OFF BLI default: OFF
Values from 001 to 100 sets the activation point for brake pedal vibration
(only available when ClubSport Pedals V3 / V3i is connected). This feature
works independently and therefore can be used with any game. It is useful
for learning threshold braking technique. OFF allows pedal vibration to be
controlled by a game directly (if supported).
5.6.11
To Next Page
Loading...
Need help?
General
