23 23
The CSL DD must not be modied dierently other than explicitly described
in this manual. Endor
®
AG expressly prohibits analysis and utilisation of the
electronics, hardware, software, and rmware contained in this device. In
case diculties occur regarding utilisation of the CSL DD, please use the
following troubleshooting guide. You will nd further details and contact
information on Fanatec.com/support/faq.
If the CSL DD is not working properly:
Clean only with a dry or slightly damp microbre cloth. Using cleaning
solutions may damage your CSL DD.
CLEANING
TROUBLESHOOTING
6
7
Problem description Solution
The steering wheel is not properly centred
after a rmware update of the CSL DD has
been performed.
After performing a rmware update of the
CSL DD, the wheel centre position must be
manually calibrated. See chapter 5.4 “Centre
Calibration” of this manual for more details.
The H-pattern shifter is not working properly
after a rmware update of the CSL DD has
been performed.
After performing a rmware update of
the CSL DD, the H-pattern shifter must be
manually calibrated. See chapter 5.5 “Shifter
Calibration” of this manual for more details.
The driver window does not show the
attached steering wheel.
Ensure that you have updated your CSL DD to
the latest rmware version which is contained
in the latest PC driver and can be downloaded
from Fanatec.com/driver.
Check the pins inside the Quick Release of
the steering wheel. These must not be bent or
damaged.
Try to use another steering wheel. If this
is also not detected the CSL DD may be
damaged.
The PC driver is unable to switch the wheel
base into update mode.
Hold power button for 8 seconds in order to
boot into bootloader mode. Attempt to update
rmwares via the Firmware Update Assistant.
To Next Page
Loading...
Need help?
General
