15 15
TUNING MENU
5.6
In order to enter the Tuning Menu, press the Tuning Menu button of the
connected Fanatec steering wheel. The Tuning Menu will be shown on the
display of the connected steering wheel. To navigate through the Tuning
Menu, use the D-Pad or FunkySwitch
TM
of the connected steering wheel.
NOTE: Read the quick guide of the connected Fanatec steering wheel in
order to perform various functions such as centre calibration via button
combinations. Tuning parameters are subject to change and may be altered
in future rmware versions.
NOTE: If you did not intend to enter the shifter calibration mode, complete
the calibration process either without a connected shifter or without moving
the shifter lever. You may then leave the shifter calibration mode at the end
of the process. This has no impact on the original calibration and you can
go ahead without a shifter.
If your shifter has no 7th gear, just acknowledge it by pressing the indicated
button for the attached steering wheel when the shifter lever is physically
in 6th gear. Shifter calibration will be completed after the 7th gear has been
conrmed.
NOTE: Instructions displayed on steering wheels featuring an OLED display
may dier slightly from each other after rmware updates.
To Next Page
Loading...
Need help?
General
