FANATEC CSL DD - Hard-Mounting

5 5
Insert the T-nuts into the T-slots found on the sides of the wheel base for
hard-mounting from the sides.
You can position the T-nuts in any conguration to suit the position of the
holes on your hard-mounting structure.
For optimum side-mounting, check out our optional PODIUM Mounting
Brackets at Fanatec.com. (M6 bolts and washers required.)
NOTE: Use only good
quality bolts when
hard-mounting.
Bolt specications:
M6x(10+X) mm
X
X
M6
M6
10 mm
10 mm
B
B