www.fanatec.com
QuickGuide
EN
Fanatec
®
is a registered trademark of Endor AG
Designed and developed by Endor AG in Germany
Manufactured by
Seligenthaler Straße 16 a - 84034 Landshut - Germany
Telephone: +49 (871) 9221-122 Fax: +49 (871) 9221-221
Email: info.webshop@fanatec.com
Internet: www.fanatec.com - www.endor.ag
TUNING MENU
To enter the tuning menu press the [TUNING MENU] button.
To navigate inside the menu, use the D-PAD [FunkySwitch
TM
]:
•
Press the [FunkySwitch
TM
] up or down to access 5 setups
(SET 1, SET 2, … 5)
•
Press the [FunkySwitch
TM
] right or left to go through the
options
•
Rotate the [FunkySwitch
TM
] left or right to change option
values. The new values are in eect immediately and will
be stored inside the wheel base.
SHIFTER CALIBRATION
To enter shifter calibration mode, simultaneously press and
hold the [TUNING MENU] +
buttons, as highlighted below.
For the detailed process read the shifter manual.
CENTER CALIBRATION
If a center calibration is needed (e. g. after rmware
update of wheel base) you need to enter the tuning menu
by pressing the [TUNING MENU] Button. “SETTING” will
appear on the OLED display. Now turn the wheel to its
center position and then press the [FunkySwitch
TM
] +
buttons at the same time to calibrate the wheel center.
To switch between modes simultaneously press and hold
the buttons
+ , highlighted below, for one second.
The wheel base LED indicates the active mode:
- Green means Xbox One mode
- Red means PC mode
- Blue means PS4
TM
mode*
- Purple means compatibility mode*
TUNING MENU
TUNING MENU
FunkySwitch
TM
* not applicable for every Fanatec wheel
base, please check the individual user
manual of your Fanatec wheel base.
MODES
SETTING
TUNING MENU
FunkySwitch
TM
To Next Page
Need help?
General
