Fanimation TR20WH - User Manual

TR20WH Remote Control
DESCRIPTION: One Ceiling Fan and Light, 3 Speed, Reversing Remote Control.
READ AND SAVE THESE INSTRUCTIONS
FAN MODELS USED: See Catalog or visit our website www.fanimation.com for more information.
SPECIFICATION and INSTRUCTION SHEET
How to Wire and Operate Your Remote Control
Figure 2a Figure 2b
Figure 3
Figure 1
Remote Control
Dip Switch
Receiver Dip Switch
NOTE: If fan or supply wires are different colors than
indicated, have this unit installed by a qualified electrician.
WARNING
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
Remote
Control
1. Remove battery cover with a small screwdriver or
ball point pen firmly press the tab and slide battery
cover off. (Figure 1)
2. Setting the Code: The remote unit has 16 different
code combinations. It may be necessary to test a
couple frequency code settings to improve signal
reception and/or eliminate interference from other
remote control household items. Multiple fans should
have different code settings to allow independent fan
control. To set the code, perform these steps.
3. Remote Control: Slide code switches to your choice
of up or down position. Factory setting is all up. Do not
use this position. With a small screwdriver or ball point
pen slide firmly up or down. (Figure 2a)
4. Receiver: Slide code switches to the same positions
as set on your remote control. (Figure 2b)
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not operate
fan unless blades are in place. Noise and fan damage
could result.
ECE
3V, CR2032
BATTERY
(2 PCS)
5. Operating & Using Remote Control (Figure 3):
Install two piece of 3 volt battery (If not using for long
periods of time, remove battery to prevent damage to
store remote control). Store the remote control away
from excess heat or humidity.
• HI Push Button - high fan speed
• MED Push Button - medium fan speed
• LOW Push Button - low fan speed
• REV Push Button - toggles airflow direction
• Push Button - fan off
• Light Push Button - on/off, hold for infinite light level

Fanimation TR20WH Specifications