Fantic XX 250 - Maintenance Table (XX 250 Version)

13 Motore1. General information
USE AND MAINTENANCE MANUAL CHAPTER 1
GENERAL INFORMATION2-Strokes - Edition 01 / 2023
62
Maintenance table (XX 250 version)
Item
After break-in Every race
(about 2.5
hours)
Every third
(about 7.5
hours)
Every fifth
(about 12.5
hours)
As required
Remarks
Piston
– Inspect and clean √√ Inspect crack.
– Replace √√
Inspect carbon deposits
and eliminate them.
Piston rings
– Inspect √√ Check ring end gap.
– Replace √√
Piston pin, small end bearing
– Inspect √
– Replace √
Cylinder head
Inspect carbon deposits
and eliminate them.
– Inspect and clean √√
Check gasket.
– Retighten √√
– Replace √ Replace the gasket.
Cylinder
– Inspect and clean √√ Inspect score marks.
– Replace √ Inspect wear.
YPVS
– Inspect and clean √√
Inspect carbon deposits
and eliminate them.
Frizione
– Inspect and adjust √√
Inspect housing, friction
plate, clutch plate and
spring.
– Replace √
Transmission
– Replace oil √√
10W-40
(API SL / JASO MA MA2)
– Inspect √
– Replace bearing √
Shift fork, shift cam, guide bar
– Inspect √ Inspect wear.
Rotor nut
– Retighten √√
Kick starter
– Inspect √
Check the idle gear for
damage.
– Replace √