B-82604EN/01 OPERATION6.ADDRESS ASSIGNMENT TO POINTS
- 33 -
location of these six %R’s in the data structure of the position register.
Here, these six %R’s are located at addresses 1 through 6 in the data
structure.
As explained above, by specifying @ in $VAR_NAME, a certain part
can be taken from the data structure of the position register that uses
50 %R’s and can be assigned repeatedly.
@1
.6
Specification of @ can be used not only for the position register but
also for all data that uses $SNPX_ASG. In the standard setting, @1.1
used for register assignment functions in a similar manner.
Another example is given. To assign J1 through J6 of PR[3] to PR[10],
set the following:
$ADDRESS $SIZE $VAR_NAME $MULTIPLY
$SNPX_ASG[1] 1 96 PR[3]@27.12 1
Number of %R’s to be taken(the number of %R’s used by one position register)
Start address of the
To Next Page
Loading...