B-82604EN/01 OPERATION6.ADDRESS ASSIGNMENT TO POINTS
- 49 -
Write the following character strings in %G sequentially:
CLRASG
SETASG 1 2 R[1]@1.1 1
SETASG 3 4 R[1] 100
SETASG 7 4 R[2] 0.1
SETASG 11 2 R[1] 0
Some commands can be written at once marking off them by
CR(0x0A) or LF(0x0D).
In this case, adding CR or LF at the end of the last command makes
the execution a little faster.
CAUTION
CLRALM command and the function writing some
commands at once are supported by R-J3iB
system software 7D80, 45 or later, and 7D81, 09
or later, and R-30iA(R-J3iC).
To Next Page
Loading...