GB
INSTRUCTIONS FOR USE
PREPARATION FOR COMMISSIONING (BEFORE START-UP)
Make sure there is suf cient fuel in the tank.
Only use a 2-stroke mixture as fuel. Unleaded petrol mixed with 2-stroke oil according a
ratio of 50:1 (2%).Total tank capacity: 4 l.
Fuel mixing procedure
Prepare the quantity of petrol that you want to add and pour it into the fuel tank
Then use the fuel tank cap to measure the specified quantity of oil. Add it into the
fuel tank
Shake the fuel tank to mix the oil and the tank, before starting the motor.
Pre-operation checks should be made each time the generator is used. The
engine and mu er will be very hot after the engine has been run. Avoid touching
the engine and muf er while are still hot with any part of your body or clothing
during inspection or repair.
If you do not use oil, the motor will overheat.
Petrol is a highly flammable and toxic substance
Do not fill over the top of the fuel filter, to prevent the fuel from overflowing
when it heats up and expands
Wipe any drips of fuel immediately
-after refueling, make sure the tank cap is tightened securely.
To Next Page
Loading...