GB-9
ENGLISH
INSTALLATION
Position the appliance and allow it to stand for two to three
hours before it is turned on for the first time to allow the system
to settle.
Do not position next to any heat source e.g. cooker, boiler or in
direct sunlight etc.
Allow at least 10cm of space at the top and 10 cm of space
on both sides of the appliance and between the back of the
appliance and the wall for adequate air circulation.
The appliance is not designed for recessed installation (“building
in”).
Install on a good firm level surface, and any unevenness of the
floor should be corrected prior to installation, slight unevenness
can be overcome by adjusting the front feet.
NOTE: If the appliance is positioned on a carpet, soft floor
covering you should readjust the front feet once the appliance
has had time to settle.
To Next Page
Loading...
