GB-21
ENGLISH
REPLACING THE LED LIGHT
Warning: the LED light must not be replaced by the user!
If the LED light is damaged, contact an authorized service
representative for repairing.
1. Unplug the appliance.
2. Remove all substances.
3. Clean the inside and outside walls with a clean sponge or soft
cloth using warm water or 1 teaspoon of bicarbonate of soda to
1.2 liters of water.
4. Rinse well and wipe dry with a clean soft cloth.
If the appliance is not to be used for a long period of time then it
is recommended to remove all the food stuff, clean the inside of
the appliance and leave the door open to allow the air to circulate
thus avoiding unpleasant odors.
Dusts behind the refrigerator and on the ground shall be timely
cleaned to improve the cooling effect and energy saving.
The interior of the refrigerator should be cleaned regularly to
avoid odor.
Check the door gasket regularly to make sure there are no debris.
Please turn off the power before cleaning, remove all food,
shelves, drawers, etc.
Clean the door gasket with mild soap and water. Use a soft
cloth or sponge to clean the inside of the refrigerator, with two
tablespoons of baking soda and a quart of warm water.
Then rinse with water and wipe clean, and open the door and
dry it naturally before the power is turned on.
For areas that are difficult to clean in the refrigerator (such
as narrow sandwiches, gaps or corners), it is recommended to
CLEANING
To Next Page
Loading...
