GB-15GB-14
intended to optimise and customise the level of
salt consumption.
Please follow the steps below for adjustment in
salt consumption.
1. Switch on the appliance;
2. Press the Start/Pause button for more than 5
seconds to start the water softener set model
within 60seconds after the appliance was
switched on;
3. Press the Start/Pause button to select
the proper set according to your local
environment, the sets will change in the
following sequence: H1->H2->H3->H4-
>H5->H6;
4. Press the On/O button to end the set up
model.
WATER HARDNESS
Selector Posi-
tion
Salt
consump-
tion (gram/
cycle)
°dH °fH °Clarke mmol/l
0~5 0~9 0~6 0~0.94
H1-Rapid light
bright
0
6-11 10-20 7-14 1.0-2.0
H2-90min light
bright
9
12-17 21-30 15-21 2.1-3.0
H3-
Rapid&90min
lights bright
12
18-22 31-40 22-28 3.1-4.0
H4-ECO light
bright
20
23-34 41-60 29-42 4.1-6.0
H5-ECO&Rapid
lights bright
30
35-55 61-98 43-69 6.1-9.8
H6-ECO&90min
lights bright
60
Note1:
1 dH=1.25 Clarke=1.78 fH=0.178mmol/l
dH: German degree
fH: French degree
Clark: British degree
Note2:
e manufactory setting: H3 (EN 50242)
Contact your local water board for information
on the hardness of your water supply.
NOTE: If your model does not have any
water softener, you may skip this section.
WATER SOFTENER
e hardness of the water varies from place to
place. If hard water is used in the dishwasher,
deposits will form on the dishes and utensils.
e appliance is equipped with a special softener
that uses a salt container specically designed to
eliminate lime and minerals from the water.
To Next Page
Loading...
Need help?
General
