EasyManua.ls Logo

FAR POWER - Problem Solving; Charging Indicator Lights Not Lit; Motor Will Not Start

FAR POWER
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ENGLISHENGLISH
GB-25GB-24
PROBLEM SOLVING
!
Make sure vacuum cleaner is o and charging
plug is unplugged.
NOTICE: ermal cut-o
is vacuum cleaner has a special thermostat
that protects the vacuum cleaner in case of
motor overheating. If the vacuum suddenly
shuts o, proceed as follows: 1) Check the
vacuum for a possible source of overheating
such as a full dust cup, blocked wand or
clogged filters. If these conditions are found,
x them and wait at least 30 minutes before
attempting to use the vacuum.
2) After the 30 minute period, press the power
button.
Problem Solution
Motor will not start Make sure cleaner is fully
powered.
Push charger securely
into electrical outlet, try
another outlet or check
circuit breaker.
See detailed “thermal cut-
o” instructions above.
Charging indicator
lights are not lit while
charging
Make sure charger is
securely inserted into
electrical outlet.
Make sure charging plug is
securely inserted into hand
vac.
Indicator lights stop
blinking when fully
charged.
DISCARDING THE VACUUM AND BATTERY PACK
!
Before you discard this vacuum, dispose
of battery in an environmentally safe
manner. Do not discard battery with
your regular household trash.
Important battery disposal information.
To nd a disposal location nearest you.