EasyManua.ls Logo

Faraday 15220A - Page 15

Default Icon
66 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
II - 5
15220A / 15240A OPERATING INSTRUCTIONS
ALARM OPERATION OF THE FIRE ALARM SYSTEM CONTROL UNIT
AN ALARM IS INDICATED BY:
A RED zone ALARM L.E.D. lights.
The YELLOW SYSTEM TROUBLE L.E.D. flashes.
The trouble buzzer sounds.
Notify the proper personnel to institute preplanned Fire
Alarm Procedures:____________________________________________
Telephone the Fire Department. (Phone No.:___________________),
to advise of the alarm and/or verify that an automatic signal
has been received at the Fire Department.
AUTHORIZED PERSONNEL ONLY
TO SILENCE THE TROUBLE BUZZER:
Push down the TROUBLE SILENCE SWITCH to the silenced position.
TO SILENCE THE BUILDING ALARM SIGNALS:
Momentarily push the SIGNAL SILENCE SWITCH. The SIGNAL SILENCE L.E.D.
will light, indicating the building alarm signals are off.
NOTE: If zone #2 has been programmed for use with waterflow switches for non-silencable signals,
once zone #2 is alarmed the building alarm signals cannot be silenced.
TO RESET AFTER AN ALARM:
First, the device which caused the alarm must be reset.
Push down the SYSTEM RESET switch for a MINIMUM of SIX SECONDS.
If the trouble buzzer had been silenced, the trouble buzzer will sound again until the
trouble silence switch is returned to the normal position.
If a trouble condition still exists, notify the proper personnel for servicing the system immediately
TROUBLE OPERATION OF THE FIRE ALARM SYSTEM CONTROL UNIT
A TROUBLE IS INDICATED BY:
The yellow SYSTEM TROUBLE L.E.D. flashes.
The trouble buzzer sounds.
TO SILENCE THE TROUBLE BUZZER:
Push down the TROUBLE SILENCE SWITCH to the silenced position.
Notify the proper personnel for servicing the system immediately.
Institute alternate Fire Alarm Procedures.
Upon repairing the trouble condition, if the trouble buzzer had been silenced, the trouble
buzzer will sound again until the trouble silence switch is returned to the normal position.
SEE THE OWNERS MANUAL (P/N 445926 Issue I) FOR FURTHER DETAILS.
LOCAL SERVICE REPRESENTATIVE
NAME:____________________________________________________PHONE:_____________________________________
ADDRESS:____________________________CITY:_______________STATE:______ZIP:_______________
FRAME THESE INSTRUCTIONS AND MOUNT THEM ADJACENT TO THE CONTROL UNIT.
445927 Issue I
firealarmresources.com

Related product manuals