Farymann Diesel K 30 - User Manual

Instructions for installing and adjusting engine belts for optimal tension.

Technical specifications for various Farymann engine models (K 30, L 30, etc.).

Specific Bosch components used in Farymann engines like injection pumps and nozzles.

Minimum battery size and other electrical system specifications for engines.

Tightening torques for various engine parts like cylinder head, con-rod, etc.

Description of single-cylinder Farymann engines with key component identification.

Detailed identification of components for single-cylinder Farymann engines.

Description of V-2 Farymann engines with key component identification.

Detailed identification of components for V-2 Farymann engines.

Information on the Ronim gearbox, including oil check and construction.

Details on the Nanni gearbox, power transmission, and serial number importance.

Information on Hurth gearboxes, helical gears, and oil checking procedures.

Guidance on engine and gearbox oil types, grades, and maintenance.

Table detailing oil capacity for various Farymann gearbox models.

Essential checks of oil, fuel, and water systems before engine operation.

Step-by-step guide for starting the engine manually using the starting crank.

Instructions for starting the engine using the electric starter system.

Guidelines for safely stopping the engine and checking after startup.

Measures to protect the engine from frost damage during cold weather.

Guidelines for battery maintenance, safe operation, and storage.

Scheduled maintenance tasks for the engine based on operating hours.

Maintenance requirements for the gearbox, including lubrication and checks.

Maintenance points for the engine's electrical system, battery, and connections.

Detailed steps for changing the engine oil, including frequency and methods.

Instructions for replacing the oil filter, including recommended types.

Procedures for cleaning the crankcase and maintaining the breather system.

How to check and adjust valve clearance on cold engines.

Adjusting V-belt tension and inspecting/replacing the water pump impeller.

Information on the engine's thermostat and cleaning deposits.

How to clean and maintain the sea water filter.

Details on fuel filter life, clogging, replacement, and fuel system bleeding.

Adjusting clutch clearance, changing gear oil, and greasing starter rim gear.

Adding distilled water and protecting battery terminals.

Steps to prepare the engine's oil and fuel systems for long-term storage.

Procedures for draining and protecting the cooling water system.

Steps for restoring the electrical system after storage.

Common causes and remedies for engine failure to start.

Troubleshooting for engines running erratically or with reduced output.

Diagnosis and solutions for engines that stall after reaching operating temperature.

Identifying causes and solutions for blue or black exhaust smoke.

Diagnosis for engine overheating, including cooling water and air supply problems.

Troubleshooting for water pump issues, air aspiration, and cooling lines.

Reasons for the oil pressure warning lamp illuminating and corrective actions.

Troubleshooting for engine over-speeding (racing) and knocking sounds.

Diagnosing why the engine fails to achieve its rated speed under load.

Guide for adjusting lube-oil quantity based on engine slope and type.

Lists recommended HD engine oils by brand and API classification.

Diagram and explanation of the Farymann fuel system, including bleeding.

Identification of components in the exhaust and cooling water system above waterline.

Identification of components in the exhaust and cooling water system below waterline.

Diagram and list of electrical components and their connections.

Diagram and list of electrical components for lever switch ignition.