Fasep FZ41/3S - Problems;Causes;Solutions

2 column
electro-mechanical lift
Mod. Z41/3S
19
WARNING! Always work under the vehicle only after turning the main
switch to the "0" position and after locking it. If assistance is required,
contact an authorised centre and use original spare parts only. The spare
parts list is attached to this instruction booklet.
Before lowering the machine, make sure that there are no objects or
obstacles in the area under the vehicle.
PROBLEMS/CAUSES/SOLUTIONS
PROBLEMS
CA
USES
SOLUTI
O
NS
The lift does not start or
it stops.
- Obstacles that prevent the
arms from descending.
- Main nut worn.
- Thermal protection.
- Up and down limit switch.
- Control buttons.
- Three phases of the mains.
Request the inter
vention of a
technician.
- Control micro out of cam. Check that the micros are at
the centre of the cam (See
Fig.
4
).