L0 USE OF IMPLEMENTS
The crane, in load condition H1B3, can be provided with implements such as:
- Manual extensions
- Winches
- Hydraulic extensions
- Personnel baskets
- Clam ‘shell buckets
- Augers
(!) When using an implement it is always necessary to check that its weight,
dimension and capacity is matched to the crane performances.
For further information please refer to FASSI GRU IDRAULICHE
Warning and norms for crane use also apply for hydraulic implement use.
Before using a personnel basket it is necessary to provide the crane with
the safety devices requested by the local norms in force and prior to use of
the crane it has to be tested and inspected in accordance with the local legal
requirements.
(!)
In case of implements on the load or the truck body it is necessary to check
they are locked to assure the impossibility of accidental movements.
(!) The crane can operate, intermit-
tently and not continuously, with
lifting devices other than the hook,
only on loose and light materials
(not on scrap iron).
The dimensions and the capacity
of the implements must be propor-
tioned with crane performances.
(!) WARNING (!)
CRUSHING OR PUSH MANOEUVRES ARE NOT PERMITTED.
L0.1 Hydraulic connections for implements - supple-
mentary hoses.
(!) WARNING (!)
To ensure that the control corresponds to the implement movement, hydraulic
connections are symmetrically fitted with coupling unions. Never invert such
positions: movements inversion as well as operating difficulties or unusual
overload with implement itself could occur.
NOTE
When using coupling unions it is necessary to verify that there is no trace of soil,
curt etc. on the unions and inside the seats so as to avoid the oil contamination
and consequently wear the tightening “ surface of unions or ram seals.
L0
USE OF IMPLEMENTS
F 170A
32
To Next Page
Loading...