B0 SAFETY NORMS
Strictly conform to the norms reported by the plates DE4236 (fig. 1) placed
next to the controls, in order to avoid possible accidents while operating the
crane.
Only authorized persons are allowed to operate the crane.
The crane must be used on firm, level ground.
Check that the vehicle hand brake is on and that the wheels are chocked.
Before every operation make sure that:
- no-one is within the working area of the crane;
- the safety devices are in place and operative;
- the minimum safe working distances from power lines are observed;
- the load is correctly slung and hooked.
Stabilize the vehicle by the outrigger rams, making sure that:
- the lateral supports are fully extended;
- the wheels are in contact with the ground and the suspension is not
completely unloaded.
Use the crane in accordance with the use and maintenance manual,
making sure that:
- the load and radius are within the maximum limits shown on the
crane capacity plate;
- the crane is used progressively avoiding sudden load movements
- swinging or dragging of the load is avoided;
- the load is lifted before rotating.
When using implements protect the crane working area with a barrier.
The vehicle/crane are not left unless the power take off is disengaged and the
load is on the ground.
Before driving the vehicle make sure that the outriggers are fully retracted and
re-entered, the safety taps closed and the crane is in folded position.
B0
SAFETY NORMS
F 170A
4
fig. 1
To Next Page
Loading...