C0 WARNING AND INSTRUCTIONS
The use of the crane is reserved to authorized personnel, instructed in advance,
who has to conform to the safety norms and instructions contained in the use
manual supplied with the crane. (See norms ISO 9926-1)
It is absolutely prohibited to walk or stop under a suspended load
It is prohibited for unauthorized persons to be within the working area.
Under no circumstances interfere with the safety and protection devices.
Warning plates, as well as instruction and operation plates must be replaced
when no longer readable or missing. See Paragraph R0 Instruction and warning
plates.
Do not use the outriggers to raise the vehicle.
To avoid hitting bridges or tunnels check and record the overall height of your
crane in the folded position or in laid position in the body or on the load. Always
respect and pay proper attention to road signs placed in proximity of such
obstacles.
C0.1 Before operating
(!) ATTENTION (!)
Check that protections are in their place and that all safety devices are fitted
and active. (See norms ISO 9927-1)
Keep the ladder and the control station on the top seat, clean; the seat can tilt
forward.
Make sure that control stations are properly lit so as to ensure safety while opera-
ting and allow instruction plates to be visible.
Check that the working area is adequate and pro-
perly lighted for your crane.
Make sure that the hook is always free to rotate on
its pin and that nothing obstructs its vertical positio-
ning.
Check the efficiency of the hook safety catch.
Carefully inspect the condition of ropes or chains.
Make sure that the pallet fork is connected to the crane hook by means of a chain
having at least three (3) rings.
C0.2 During operation
Take the vehicle fumes away from the working area by fitting an extension tube of
a suitable diameter to the exhaust system.
Do not run the engine in a indoor area without first making sure there is adequate
ventilation.
When using the ladder to reach the control station on the top seat, avoid knocking
into the controls while going up or down the ladder.
The control station on the top seat is provided with side safety guards; stay within
these guards.
Make sure that no one is within the working area of the crane.
Avoid swinging the load above working and transit areas; any hidden danger
situation must be audibly alarmed.
C0
WARNING AND
INSTRUCTIONS
F 170A
5
To Next Page
Loading...