Fastcorp DIVI - Page 34

Fastcorp, LLC
DIVI Setup and Users Guide
Page 34 of 62 Rev 6
O. LINE MODE -
Line mode shortens the time between vends by holding the freezer door open between vend cycles. If there is
no activity for 20 seconds the Freezer Lid will close. (Default setting is OFF).
P. MACHINE SERIAL NUMBER -
Program the serial number of the vendor into the VMC memory so that an external data retrieval unit (DEX) can include the
serial number when uploading sales information. Up to 10 digits are allowed. Defaults to VMC Board serial number.
Q. FILL / DISPENSE:
Allows coin count to be viewed for up to 5 coin changer tubes. Coins may be dispensed from tubes 1 through 5
R. TOKENS & COUPONS –
This allows the machine to recognize coupons and tokens as free vends when the Promotional
feature is on. Item and price will be recorded as a free vend in the DEX report.
Display
Programming Instructions
16) LINE MODE
a) Press the #=Yes key to enter Menu Option.
* = Next
D = Back
# = Yes
LINE MODE: ON
b) Press the *=Next key to scroll between options.
c) Press the #=Yes key to confirm the selection.
* = Next
D = Back
# = Yes
Display
Programming Instructions
17) Machine Serial #
a) Press the #=Yes key to enter Menu Option.
* = Next
D = Back
# = Yes
SN
0000000000
b) Enter 10 digit ID number (asset #, machine serial #,
etc.). Press #-Save.
*-Exit
#-Save
MACHINE SN SAVED
c) Save serial number is confirmed.
USE FOR
d) Select 1 to assign this number to coin changer. Select
2 if no.
CHANGER SN?
1-YES
2-NO
d) Select option 1 or option2.
Display
Programming Instructions
18) FILL / DISPENSE
a) Press the #=Yes key to enter Menu Option.
* = Next
D = Back
# = Yes
Select Tube 1 to 5
b) Enter any tube number: 1 to 5 to dispense a coin and
view coin count.
# - EXIT
Display
Programming Instructions
19) TOKENS & COUPONS
a) Press the #=Yes key to enter menu option.
* = Next
D = Back
# = Yes
Tokens / Coupons off
b) Press the “*” key to scroll between “On” and “Off”.
c) Press the “#” key to accept selection.
*= Change
#=Accept