Fat Shark DOMINATOR - User Manual

Questions and Answers

J
Jonathan PeckAug 17, 2025
Why is my Fat Shark Headsets reception so poor?
- C
  campbelltimothyAug 17, 2025
  Poor reception in your Fat Shark Headsets can stem from several factors. Ensure maximum separation between RC and video antennas. Shadowing of the VTX antenna can be another cause, so try a different VTX antenna with a longer coaxial section. A loose VTX antenna connection can also degrade performance; ensure it's secure. Overheat protection mode in the VTX can also be the reason; disconnect power to cool it down. Also, improve airflow to the video transmitter RF board, and move the goggles away from sources of RF interference like Wi-Fi routers.
J
Joseph JonesAug 19, 2025
How to fix video recording not working on Fat Shark Headsets?
- J
  Joshua LongAug 19, 2025
  If video recording isn't working on your Fat Shark Headsets, it might be due to several reasons. First, the SD card may not be formatted correctly, so reformat it using the goggles. Another reason might be that there's less than 200MB available on the SD card, so replace the card or clear some space. Finally, ensure you have a solid video signal by focusing on improving reception first.
M
Mr. Kevin JordanAug 22, 2025
Why is my Fat Shark video gaming accessory showing a dark grey screen?
- V
  vincent75Aug 22, 2025
  If you're seeing a dark grey screen on your Fat Shark video gaming accessory, here are a few things to check: * If you're using a wireless module, make sure the RX power is turned on at the bottom of the headset. * If you're using an AV in cable, verify the video source is working correctly. * Also, confirm that the TX is powered on and all camera connections are secure.
C
christopher18Aug 25, 2025
What to do if my Fat Shark video gaming accessory lens fogs up?
- M
  marthabowenAug 26, 2025
  If the lens of your Fat Shark video gaming accessory fogs up, it's likely because the cooler optical lens is being heated by your humid face, causing condensation. A simple solution is to pre-warm the goggles by wearing them on your head before use.
B
Brian NovakAug 28, 2025
How to fix short range on Fat Shark video gaming accessories?
- G
  George MeyersAug 28, 2025
  To improve the range of your Fat Shark video gaming accessory, consider the following: * Make sure the correct antennas are properly installed. * Check for any potential sources of interference. * Ensure the transmitter has a clear line of sight to the headset, testing in an open area away from obstructions.
S
Samantha RayAug 30, 2025
How to fix short range on Fat Shark video gaming accessories with wrong antenna?
- P
  Pamela CampbellAug 31, 2025
  To resolve range issues with your Fat Shark video gaming accessory, ensure that a compatible antenna is installed. Remember, a 2.4Ghz system must use a 2.4Ghz antenna, and a 5.8Ghz system must use a 5.8Ghz antenna. Avoid using antennas from other manufacturers, as they may be dual band or have a reverse SMA connector, preventing a proper connection to the receiver.
S
Susan RobinsonSep 2, 2025
What to do if Fat Shark video gaming accessory has interference lines with 2.4Ghz receiver?
- N
  Nicole GrantSep 2, 2025
  If you're experiencing interference lines with a 2.4GHz receiver on your Fat Shark video gaming accessory, try these steps: * Select a cleaner channel. * Switch to 5.8GHz AV. * Verify that the correct frequency antenna is being used.
G
Gregory PriceSep 5, 2025
What to do if Fat Shark video gaming accessory has interference lines with 5.8Ghz receiver?
- P
  Paula AllenSep 5, 2025
  If you're seeing interference lines when using the 5.8Ghz receiver on your Fat Shark video gaming accessory, check if the issue is harmonic interference from a 2.4Ghz RC controller by turning the radio on and off. If that's the cause, use CH1 on the TX/headset, as it's not affected by 2.4Ghz. Also, ensure the correct frequency antenna is being used.
D
Donna HunterSep 7, 2025
How to fix Fat Shark video gaming accessory head tracker not working?
- J
  John BrooksSep 7, 2025
  If the head tracker on your Fat Shark video gaming accessory isn't working, try the following: * Ensure the module pins are correctly aligned in the headset socket. * Review the controller manual for the correct settings. * Check that the servos are plugged into the correspondingly selected channels.
S
Sydney PowellSep 10, 2025
Why is my Fat Shark video gaming accessory display completely dark?
- R
  richardriosSep 12, 2025
  If your Fat Shark video gaming accessory display is completely dark, check the power connections.