Need help?Do you have a question about the FATEK CBEH and is the answer not in the manual?
Explains the registers and status values related to the active call back feature for remote maintenance.
Guides users on configuring the CBEH module using the Ether_Config software, covering network settings and operation modes.
Explains the steps to connect to the CBEH expansion board via a local area network using the Ether_Config software.
Details how to set the IP address, subnet mask, and gateway for the CBEH module using static or DHCP acquisition modes.
Describes how to configure the operation mode for Port1 (Fatek Server) and Port2 (Modbus/Fatek Client) on the CBEH module.
Explains how to configure the CBEH module using its built-in web server interface via a web browser.
Details the system page interface for basic configuration, external services, and real-time monitoring of the CBEH module.
Covers setting the module's network address, mask, and gateway parameters through the web interface's General setting page.
Guides on setting the operation mode for Port2, choosing between Fatek Client, Modbus Server, or Modbus Client.
Describes the steps to transfer the designed custom webpage content from Easy Web Designer to the CBEH expansion board.
Guides on using email services to send SMS notifications, detailing configuration for providers like Message Media.
Provides steps to enable internet clock synchronization using Ether_Config software or a web browser.
Provides a step-by-step example of setting up and executing the active call back function for remote maintenance.
Outlines the procedure for updating the CBEH module's firmware using the Ether_Cfg software and downloading the image file.
General| Model | CBEH |
|---|---|
| Category | Control Unit |
| Supply Voltage | 24 VDC |
| Input Voltage | 24 VDC |
| Output Voltage | 24 VDC |
| Output Type | Relay |
| Number of Outputs | 16 |
| Communication Interface | RS-485 |
| Storage Temperature | -20°C to 70°C |
To Next Page
