Need help?Do you have a question about the FATEK CBEH-2A and is the answer not in the manual?
Details the core capabilities of the CBEH series, including PLC internet communication and custom webpage design.
Details the mechanism for remote maintenance, enabling the CBEH to initiate connections to a maintenance center.
Explains how to configure the CBEH module using the dedicated Ether_Config software utility.
Explains how to configure the CBEH module's settings using a standard web browser.
Describes how to set IP address, subnet mask, and gateway parameters via the web interface.
Details how to configure and send emails from the CBEH module for maintenance or status alerts.
Explains the process of sending SMS messages via email, including setup with service providers.
Provides steps to enable and configure internet clock synchronization using Ether_Config or web browser.
Describes the synchronization process between the CBEH's RTC and network time using PLC registers.
Guides on adding specific PLC registers or contacts for real-time monitoring via the web interface.
Step-by-step instructions for performing the firmware update process for the CBEH expansion board.
General| Input Voltage/Power Supply | 24VDC |
|---|---|
| Communication Ports | RS-232, RS-485 |
| CPU Type | 32-bit |
| Digital Inputs | 8 |
| Digital Outputs | 6 |
| Analog Inputs | 2 |
| Programming Language | Ladder Diagram |
| Humidity | 5% to 95% RH (non-condensing) |
To Next Page
