58
service provider for the Email body. For Message Media, the information needed to
be entered in the Email body are service account, service password, and the mobile
phone number that is going to receive the SMS. (Note: Under Email to SMS
mode, the SMS content received by the mobile phone is the subject
content.)
Step 3, Transfer the Email configuration
After completing the basic Email settings, these information must be sent to the
FBs-CBEH series expansion board. Click “Tools” -> “Download Email configuration”
from the main menu
The “Email Configuration transfer” window will appear at this time; in the “Target IP”
field, fill in the IP address of the FBs-CBEH series expansion board to download the
configuration, then confirm that the correct password is entered in the “Password”
field and press the “Start Download” to perform the downloading.
Step 4, control the FBs-CBEH series expansion board to execute Email sending.
After completed uploading the Email configuration, the Email sending function can
be used; the figure below is a simple control program which uses one contact to set
the Email command code register D3961’s value as 0x3370, then it will execute Email
To Next Page
Loading...
