To Next PageTo Next Page
Need help?Do you have a question about the FATEK FBs-14MA Series and is the answer not in the manual?
General| Brand | FATEK |
|---|---|
| Model | FBs-14MA Series |
| Category | Controller |
| Language | English |
Provides a table listing model numbers and their specifications.
Outlines technical specifications for the Main Unit, including memory, commands, and registers.
Explains the block diagram of a single-unit FBS-PLC system with I/O and communication resources.
Discusses integrating multiple PLC systems for resource sharing.
Covers expansion of Digital I/O and Numeric I/O through cascaded units/modules.
Explains expanding communication ports using Communication Boards (CB) and Modules (CM).
Outlines essential precautions for installing the PLC to avoid interference.
Provides guidelines for safe and proper wiring construction.
Lists specifications and wiring details for available AC power supplies.
Outlines specifications and wiring for DC power supplies, including warnings.
Details residual capacity of power supplies and current consumption of expansion modules.
Explains the power sequence requirements for main units and expansion modules.
Details specifications for DI circuits, including voltage, current, and status indication.
Lists specifications for digital output circuits, including protection and wiring.
Explains single-end output structures for relays, transistors, and TRIACs.
Covers protection and noise suppression for output devices like relays and transistors.
Provides a checklist for pre-power-on inspections after wiring.
Explains the process of test running the PLC and monitoring its operation.
Details the meaning of PLC LEDs and basic troubleshooting steps.
Introduces the fundamental principles and elements of ladder diagrams.
Explains the structure of ladder diagrams and defines key terminology like elements and nodes.
Provides guidelines for translating ladder symbols into mnemonic instructions.
Illustrates the memory structure of FBS-PLC, including SRAM and FBS-PACK.
Details the allocation and range of digital and register operands (bits and words).
Lists sequential instructions with their operands, symbols, and execution times.
Introduces basic and advanced function instructions, including mathematical and logical operations.
Explains the T Timer instruction, including time bases, preset values, and operation.
Details the C Counter instruction, covering preset values, counting modes, and descriptions.
Details the ADDITION instruction for performing addition of data.
Explains the SUBTRACTION instruction for performing subtraction of data.
Covers the MULTIPLICATION instruction for multiplying data.
Details the DIVISION instruction for performing division of data.
Details the COMPARE instruction for comparing data and outputting results.
Details WDT and RSWDT instructions for watchdog timer control.
