FATEK SD3 Series - Page 3

3
1
2
3
4
5
6
7
8
9
SD3 Series Instruction Manual
Overview of the SD3 Series Instruction Manual
1. Introduction
Safety Precautions, Safety Standards, Maintenance and Inspection, and
Warranty
2. Specications
Model Codes, Component Identications, Specications, and Dimensions
3. Preparation
Installation, System Wiring, and Timing Diagrams
4. Connections
CN1 User I/O Connector Pinout Options and Control Modes
5. Setting Parameters
Setup Panel and Parameters
6. Operations
Operation Options for Control Mode, Internal Position Command
(Point Table)
,
and Homing
7. Tuning
Tuning, Control Block Diagrams, Tuning Parameters
8. Troubleshooting
Warnings, Alarms, and Troubleshooting
9. Appendices
Absolute System, Emergency Stop, System Block Diagram, and Status Variables