FAURE-HERMAN
COMPONENT MAINTENANCE MANUAL
744-082 / 744-082-3
28-49-91
INTRO - PAGE 1003
MAR 31/07
INTRODUCTION
1. GENERAL
The illustrated Parts List (IPL) is prepared in compliance with ATA 100. The IPL is intended to identify
all the components of the unit.
The Illustrated Parts List contains the following sections :
- Introduction,
- Vendors Code Index,
- Equipment Designator Index (if applicable),
- Alphanumeric Index of Manufacturer's Part Numbers,
- Detailed Parts List.
2. HOW TO USE DETAILED PARTS LIST
The Detailed Parts List includes the nomenclature and illustrations of the unit components.
The Detailled Parts List columns are arranged as follows :
- 1st colomn : Fig. Item - (Figure and Item number).
- 2nd column : Part Number - (Manufacturer's part number).
- 3rd column : Airline Part Number.
- 4th column : Nomenclature.
- 5th column : Usage code - (Effectivity).
- 6th column : Units per Assy. - (Quantity per next higher assembly).
A. Figure and item numbers
Each part-numbered assembly, sub-assembly or item listed in the parts list is assigned an item
number.
The figure number, covering items listed, is indicated on the first line at the top of each page.
Assemblies, sub-assemblies and parts listed, but not illustrated, are identified by a dash (-)
preceding the corresponding item numbers.
The document reference is online, please check the correspondence between the online documentation and the printed version.
To Next Page
Loading...
