• Current Altitude of the vehicle
• Status of Selec-Speed Control and
Sele
cted Speed in MPH (km/h)
DRIVETRAIN
The Drivetrain page displays information
concerning the vehicle’s drivetrain.
The following information is displayed:
• S
teering angle in degrees
• Stat
us of Transfer Case
• Stat
us of the Rear Axles — If Equipped
PITCH AND ROLL
The Pitch And Roll page displays the
vehicle’s current pitch (angle up and down)
and roll (angle side to side) in degrees.The
pitch and roll gauge provide a visualization of
the current vehicle angle.
ACCESSORY GAUGE
The Accessory Gauge page displays the
current status of the vehicle’s Coolant
Temperature, Oil Temperature, Oil Pressure,
Transmission Temperature, and Battery
Voltage.
TRUCK BED
POWER INVERTER
There is a 115 V (400 W) exterior power
inverter located on the right rear side of the
truck bed near the tailgate. This inverter can
be turned on by the Instrument Panel Power
Inverter switch located to the left of the
steering wheel. This inverter can power
cellular phones, electronics, and other low
power devices requiring power up to 400 W.
Certain high-end video game consoles
exceed this limit, as will most power tools.
Exterior Truck Bed Power Inverter
NOTE:
• 400 W is the maximum for the inverter,
not
each outlet.
• If two outlets are in use, 400 W is shared
amon
gst the devices plugged in.
• The Power Inverter will only turn on if the
igni
tion is in the ACC or ON/RUN position.
• Due to built-in overload protection, the
Powe
r Inverter will turn off if the power
rating is exceeded.
BED LIGHTS — IF EQUIPPED
The bed lights (if equipped) are turned on by
pushing the bed light switch located on the
lower half of the headlight switch.
Bed Light Switch
To Next Page
Loading...
