How to display decimal point on FE PXR7 Microcontrollers?
If a decimal point has not been displayed on your FE Microcontroller, it might be because “0” is set in the parameter . To display the decimal point, set the parameter to “1” or “2”.
Why does the display on my FE PXR7 Microcontrollers show incorrect values?
If the display on your FE Microcontroller is showing unexpected values, it could be due to several reasons. First, the setting might not be correct for the input signals from sensors. Also, check if the polarity of the sensor matches the PXR; if not, correct it. Input terminals may be short-circuited in thermocouple B or R; in this case, set the parameter to 3 and check the temperature. The input signals of sensors might not match those of your controller, which may require adaptations or a replacement. Ensure the connecting cables for the sensor are tightened. Finally, a break or short-circuit in the sensor, or issues with the sensor or other input devices connected to the PXR, could be the cause; replace the sensor or input devices as needed. Also, verify that the set value of parameter ...
Lists and describes all operational and configuration parameters for the PXR.
Explains fundamental user interactions and display functions of the PXR controller.
Details the purpose and configuration procedures for various control parameters.
General| Brand | FE |
|---|---|
| Model | PXR7 |
| Category | Microcontrollers |
| Language | English |
To Next Page