Fein ABS18 Q - Page 17

17
en
ABS18 Q (**) (figure 9).
Set the desired operating mode.
– For drilling, adjust the torque setting to the
“drilling” symbol.
– For screwdriving, set the operating mode
selector switch to the “screwdriving” sym-
bol.
ASCM18 QSW (**) (figure 10).
Set the desired operating mode.
For drilling, adjust the torque setting to the
“drilling” symbol.
Fig. 9
Fig. 10
OBJ_BUCH-0000000311-001.book Page 17 Friday, May 4, 2018 9:20 AM