18
en
Setting the torque (figure 11).
Adjust the torque only when the machine is at
a complete stop.
The torque setting is for the small to mid-size
screw range.
The tightening torque also depends on the
force with which the power tool is pressed
against the screw.
– Low torque: Small screws
– High torque: Large screws
Determine the torque setting with which the
screws are screwed flush into the material by
practical testing.
Fig. 11
2
4
6
8
10
12
14
16
18
20
22
Torque setting
20
1
ASB18 Q (**)/ABS18 Q (**)
ASCM18 QSW (**)
Torque setting
OBJ_BUCH-0000000311-001.book Page 18 Friday, May 4, 2018 9:20 AM
To Next Page
Loading...
