3. Extend and feed the j-box wires through the openings on the
mounting gasket (5) and the mounting plate (6).
NOTE:
Tear away at perforation on mounting gasket (5)
3. Extend and feed the j-box wiresthrough the openings on the
mounting gasket (5) and the mounting plate (6).
NOTE:
Do not tear away at perforation on mounting gasket (5)
4. Secure the mounting gasket (5) and the mounting plate (6) to
the mounting bar (2) using the mounting bar screw (9). Do not
over tighten.
4. Secure the mounting gasket (5) and the mounting plate (6) to
the mounting bar (2) using the mounting bar screw (9). Do not
over tighten.
To Next Page
Loading...