Feiyu G6 Plus User Manual (English)

To Next Page

Guilin Feiyu Technology Incorporated Company

Guilin Feiyu Technology Incorporated Company www.feiyu-tech.com service@feiyu-tech.com

- 1 -

G6 Plus Gimbal Firmware Upgrade Manual

for Windows

Attention

● Please get G6 Plus ready, along with USB cable, USB connector and computer before

operating.

● This software is just compatible with Windows operation system.

● Please do not press any other buttons except the ones indicated by the instructions

during upgrade.

● Please insert the battery before upgrading.

● Connect micro USB cable to USB connector as indicated by the following before

operating.

Steps

1. Download the USB driver from Feiyu official website www.feiyu-tech.com then install

it. Next, download the upgrade software and the firmware for G6 Plus.

2. Connect USB connector to USB port of the computer. Then check port number in

Device Manager. If the COM number is more than COM10, please modify it to the

available number which is within COM10.

Need help?

Do you have a question about the Feiyu G6 Plus and is the answer not in the manual?

Feiyu G6 Plus Specifications

General

Download and install the USB driver from the official website, then obtain the upgrade software and firmware.

Connect USB, check Device Manager for COM port, open software, and set COM and baud rate.

Connect the gimbal, select the firmware file, start the upgrade, and confirm completion.

Select gimbal upgrade mode, connect, choose firmware, start upgrade, and finalize.

Address issues where the 'LINK OK' status does not appear when pressing the function button.

Solutions for 'SEND FAIL' errors and ensuring the function button is held correctly.