09 10
Battery Charging Status.
Constant
Current
mode /
Constant
Voltage
mode
< 2V/cell 4 bars will flash in turns.
2 ~ 2.083V/cell
The right bar will be on and the other three bars
will flash in turns.
2.083 ~ 2.167V/cell
The two right bars will be on and the other two
bars will flash in turns.
> 2.167 V/cell
The three right bars will be on and the left bar
will flash.
Batteries are fully charged.
4 bars will be on.
Floating mode
Status Battery voltage LCD Display
4.4 LCD setting
After pressing button for 3 seconds, the unit will enter setting mode. Shortly press button to select setting programs.
And then, pressing button for at least 1.5 seconds to confirm the selected program. After that, shortly press button to
modify the parameter of the program. If pressing button for at least 1.5 seconds, you will return to previous menu. After
waiting for 10 seconds without any action, it will automatically exit setting mode.
MPPT solar charge controller MPPT solar charge controller
Battery type
0 2
Use-Defined(Default)
If “Use-Defined” is selected, battery
charge voltage can be set up in
program 3 and 4.If “LIb” is selected,
battery charge voltage can be set up in
program 3 .
Note: "Lib” mode can only be displayed
after parameter 05 is set as one of 12V
24V / 48V.If you want to set “Lib”, first
set the 05 battery rated voltage (MPPT
45A(12/24V) can't set the Absorption
voltage to 48v, LIb mode can't set the
AUO), then set 02 to "LIb"
AGM
Setting Programs:
0 0
Program Description Options
Exit setting mode
Escape
Maximum charging current
0 1
45A(Default)
Setting range is from 30A ,45A ,60A ,
80A,100A or 120A. Increment of each
short press is 1A. The value will be
back to 10A once the value is a 30A,
45A ,60A , 80A, 100A or 120A.
60A(Default)
80A(Default)
100A(Default)
120A(Default)
Absorption voltage
0 3
If this program is selected
to modify,the changeable
figure will be shown
as below.
Increment of each short press is 0.1.
Once the value is achieved 15.0V, the
value will jump back to 12.0V.
If “Use-Defined” is selected in program
02, this program can be set up. The
setting range is from12.0V to 15.0V.
If “LIb” is selected in program 02,
the setting range is from 12.0V to
15.0V/24.0V to 30.0V/48.0V to 60.0V
14.40V (Default)
0 4
Float voltage
13.6V (Default)
If this program is selected
to modify, the changeable
figure will be shown as
below.
If “Use-Defined” is selected in program
02, this program can be set up. The
setting range is from 12.0V to 15.0V.
If “LIb” is selected in program 02,this
parameter is consistent with Absorption
voltage
Increment of each short press is 0.1V.
The value will jump back to 12.0V after
15.0V is achieved.
LIB
30A(Default)
To Next Page
Loading...
Need help?
General