1. Remove bolt from center of dash cowl.
2. Attach yoke bracket (A) using one 8mm bolt.
3. Tighten Bolts.
YOKE BRACKET
1. Remove plastic plug from floor mat and drill hole out
to 9/32” diameter
2. Attach door post (A) using one 1/4” x 3/4” bolt and
nut.
DOOR POST
IMPORTANT
CAREFULLY STUDY THE PHOTO DIAGRAMS SHOWING THE
LOCATION OF EACH PART. LEAVE ALL HARDWARE LOOSE
UNTIL INSTRUCTED TO TIGHTEN.
A
A
To Next Page
Loading...