1. Right window is to be bend to conform to side arm by
placing on a table and bending by hand.
2. Using same procedure as left window, attach right
window to windshield and side arm using three #10 x
3/4” bolts, clips, and nuts..
3. Tighten bolts.
RIGHT WINDOW
1. Mark location holes in windshield to left window (A)
2. Cut 5/8” slots next to wire frame of left window and
attach to windshield using two #10 x 3/4” bolts and
nuts.
3. At location (B) cut 5/8” slots inside window and top of
door and attach using one #10 x 3/4” bolt, nut & clip.
4. Tighten bolts.
LEFT WINDOW
A
B
1. Position door latch (A) under bottom rear of door.
2. Door is to set firmly in loop of door latch. Change po-
sition up or down with adjustment holes
3. Attach to grab handle using one “U” bolt and nut.
4. Tighten all bolts.
DOOR LATCH
A
To Next Page
Loading...