Femi 732 - User Manual

Questions and Answers

W
wwillisAug 12, 2025
What to do if my Femi 732 Saw motor is not working properly?
- C
  Christopher LindseyAug 13, 2025
  If the motor of your Femi Saw isn't working, the possible causes include a faulty motor, power cable, or plug; blown fuses; or damaged brushes (for versions with a brushed motor). It's recommended to have the machine checked by expert personnel, especially concerning the motor, due to potential dangers. Check the fuses and replace them if necessary. If your model has brushes, have them replaced by expert personnel.
C
Christopher RyanAug 17, 2025
Why does the motor on my Femi 732 Saw tend to overheat?
- E
  Emily McdanielAug 17, 2025
  The motor of your Femi Saw might overheat due to motor overload or insufficient motor cooling. To resolve this, avoid overloading the motor during cutting operations. Also, remove dust from the motor to ensure proper airflow for cooling.
R
rodriguezalexanderAug 20, 2025
What to do if my Femi 732 motor does not reach full power?
- J
  Joshua TurnerAug 20, 2025
  If the motor of your Femi Saw isn't reaching full power, it might be due to overloaded mains system circuits caused by lights, utilities, or other motors. Try to avoid using utilities or other motors on the same circuit as the saw.
F
featonAug 25, 2025
Why does the Femi 732 motor start slowly or not reach operating speed?
- B
  Brett MooneyAug 25, 2025
  If your Femi Saw motor starts slowly or doesn't reach operating speed, it could be due to low power supply voltage or damaged windings. You should ask the power supply company to check the available voltage. Also have the machine motor checked by expert personnel.
K
Katherine NicholsAug 27, 2025
How to fix a Femi 732 motor that is making too much noise?
- G
  Gary Roberts DDSAug 27, 2025
  If your Femi Saw motor is making too much noise, it could be due to a faulty motor or damaged windings. It's recommended to have the machine motor checked by expert personnel.
B
benitezmandyAug 31, 2025
What causes a rough or uneven cutting finish with my Femi 732?
- T
  tiffany52Aug 31, 2025
  A rough or uneven cutting finish with your Femi Saw can be caused by a worn-down blade or teeth that aren't suitable for the material's thickness. Have the blade sharpened by a specialized company and check that the teeth on the blade are appropriate for the material you're cutting.
E
Erin PowellSep 4, 2025
How to deal with reduction in cutting capacity of Femi Saw?
- M
  Mr. David MoodySep 4, 2025
  A reduction in the cutting capacity of your Femi Saw might be because the blade has been sharpened many times, reducing its diameter. Adjust the limit switch for head lowering.
J
James JohnsonSep 8, 2025
Why is my Femi 732 causing splintering of the cut workpiece?
- L
  Lindsey DawsonSep 8, 2025
  If your Femi Saw is causing splintering of the cut workpiece, it could be because the blade’s teeth aren't suitable for the material being cut. You should check to ensure you are using the correct teeth for the workpiece.